Flysmart Digi

Matek H743-WING V2 Flight Controller

數量

簡介

+ FC Specifications: MCU: STM32H743VIT6, 480MHz , 1MB RAM, 2MB Flash IMU: MPU6000 (SPI1) & ICM42605 (SPI4) Baro: Infineon DPS310 (I2C2) OSD: AT7456E (SPI2) Blackbox: MicroSD card slot (SDIO) 7x Uarts (1,2,3,4,6,7,8) with built-in inversion. 13x PWM outputs(including “LED” pad) 2x I2C 1x CAN 6x ADC (VBAT, Current, RSSI, Analog AirSpeed, VB2, CU2) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) 1x SPI3 breakout USB/Beep Extender with Type-C(USB2.0) Dual Camera Inputs switch 5V/9V(12V) for Camera/VTX power switch High-precision Current Sense (90A continuous, 220A peak) Battery Voltage Sensor: 1K:10K (Scale 1100 in INAV, BATT_VOLT_MULT 11.0 in ArduPilot) ADC VB2 voltage divider: 1K:20K ADC AirSpeed voltage divider: 20K:20K Static power 160mA@5V FC Firmware: ArduPilot(ChiBiOS): MATEKH743 INAV: MATEKH743 PDB: Input voltage range: 8~36V (3~8S LiPo) w/TVS protection 2x ESC power pads Current Senor: 220A, 3.3V ADC (Scale 150 in INAV, 66.7 A/V in ArduPilot) Sense resistor: 90A continuous, 220A peak. BEC 5V output: Designed for Flight controller, Receiver, OSD, Camera, Buzzer, 2812 LED_Strip, Buzzer, GPS module, AirSpeed Output 5.15 +/- 0.1V DC Continuous current 2 Amps, 3A Peak BEC 9V /12V output: Designed for Video Transmitter, Camera, Gimbal ect. Continuous current 2 Amps, 3A Peak 12V option with Jumper pad BEC Vx output: Designed for Servos Voltage adjustable, 5V Default, 6V or 7.2V via jumper Continuous current 8 Amps, 10A Peak BEC 3.3V output: Linear Regulator Continuous current: 200mA Physical: Mounting: 30.5 x 30.5mm, Φ4mm with Grommets Φ3mm Dimensions: 54 x 36 x 13 mm Weight: 30g with USB extender Including: 1x H743-WING 1x USB(Type-C)/Beep (Passive buzzer) Extender 1x 20cm JST-SH-6P to JST-SH-6P cable for USB extender. 2x 20cm JST-GH-4P to JST-GH-4P cable for CAN & I2C port 1x Rubycon ZLH 35V 470uF capacitor Dupont 2.54 pins (Board is shipped unsoldered)

你可能感興趣的商品