Flysmart Digi

Matek F411-WTE Flight Controller

Quantity

Summary

+ FC Specifications MCU: 100MHz STM32F411CEU6 IMU: BMI270 (SPI) Baro: SPL06-001 (I2C) OSD: AT7456E (SPI) Blackbox: No 2x Uarts 2x Full Softserial 6x PWM outputs (2x Motors, 4x Servos) 1x I2C 4x ADC (VBAT, Current, RSSI, AirSpeed) 3x LEDs for FC STATUS (Blue, Red) and 3.3V indicator(Red) Built in inverter on UART2-RX for SBUS input Switchable Dual Camera Inputs Vbat power ON/OFF switchable for VTX and camera PPM receiver: not supported Power 6~30V DC IN (2~6S LiPo) 132A Current Sense (Scale 250) PDB/Current sense resistor: 90A continuous, 132A burst. BEC 5V 1.5A for FC & Peripherals BEC Vx 5A for servos, 5V/ 6V option Vbat for VTX and camera (ON/OFF switchable) LDO 3.3V 200mA Battery Voltage Sensor: 1k:10k FC Firmware INAV Target: MATEKF411TE ( INAV4.1 or newer) Physical Dimensions: 31 x 26 x 16.5 mm Mounting: 22 x 22mm, Φ2mm Weight: 10g Including 1x FC F411-WTE Dupont 2.54 pins (Board is shipped unsoldered) NOTES: F411-WTE has INAV fw 4.1.0 preloaded for QC Start with INAV5.0, MatekF411TE target will be listed in INAV configurator. INAV Firmware 4.x can be downloaded from Matek website.

You might also like