Happymodel ELRS EPW6 900MHz 6CH PWM Receiver

數量

簡介

+
Specifications: Item: Happymodel EPW6 900MHz pwm receiver ESP8285, SX1276 Antenna connector: IPEX MHF 1/U.FL 6x PWM outputs RF Frequency: 868MHz(EU), 915MHz(FCC) Telemetry power: <17dbm Receiver protocol: PWM or CRSF Input voltage: +5V DC @ “+” pad PCB size: 18.5mm x 16mm Weight: 1 g without antenna Default firmware version: ExpressLRS v2.0 Firmware target: DIY_900_RX_PWMP(Factory default firmware), PWM receiver via 1~6 PWM outputs HappyModel_RX_ES900_RX, CRSF Serial receiver via TX and RX Firmware update via UART or WIFI Package Included: 1 x Happymodel EPW6 900MHz pwm receiver 1 x 915MHz antenna 1 x 868MHz antenna 3 x 6pin 2.54mm Bind Procedure: Supply power to the EPW6 RX, wait until the Green LED on the RX is off, immediately turn off the power, and then repeat again the above steps. When the RX is powered on for the third time, the Green LED light will start to double-flash, which means that the RX enters the binding mode Get into menu of ELRS.LUA V2.0 version from your radio transmitter and then press BIND, the Green LED on the RX module will getting to be solid if bind successfully. Receiver LED status meanings: LED solid means bind successful or Connection established; LED double-flash means in bind mode; LED flash slowly means no signal connection from the TX module; LED flash fast means in WIFI hotspot mode, you can connect the WIFI of the RX and upgrade firmware of the RX via visit 10.0.0.1 from the web browser(password: expresslrs) Use of this apparatus in Hong Kong is illegal ─ sale for export only.

你可能感興趣的商品